VirtualBox

Custom Query (16363 matches)

Filters
 
Or
 
  
 
Columns

Show under each result:


Results (796 - 798 of 16363)

Ticket Resolution Summary Owner Reporter
#3285 fixed Usability problem with "interfaces list" in configure Network panel Vladimir
Description

First, thanks for the great tool! Second, I'd like to point some usability problem: 1)

  • when choose Host Interface option => *list* with available interfaces become active, but it's not clear that selection in that list is so important.

If instead usual list there were items with radio buttons it will be easier to understand that selection is so important. + when you wifi connected it's preferable to have wifi interface "selected" by default, when wired connection => select bge (or other) by default 2) I have wired connection at work and wifi at home (both DHCP) when I shutdown VM at work and start it again at home => I have to remember to change used network interface. It would be great to see, that now wired interface is down on general page in Network section (i.e. red text color)

Thanks! Vladimir

Less errors and no need to restart VM.

#3287 fixed Difficult to use Virtual Box under Semantic protected Guest Vladimir
Description

Company policy claims to install Semantic firewall and antivirus protection on each Windows system. I have installed WinXP into guest VM and before installing Semantic package all was fine. But after installing WinXP CPU shows 100% almost forever and it's impossible to open any application in guest system, because it's always busy. Disabling only antivirus doesn't help. Only uninstalling Semantic package helps. The same package installed in "non virtual" WinXP is absolutely silent. Any workaround? Thanks, Vladimir

#7039 obsolete usb device gets stuck in 'captured' state, not connected to either host or guest Vladimir Vukicevic
Description

This is with VirtualBox 3.2.4 under Windows 7 64-bit, with an Ubuntu 10.04 guest.

I'm doing some Android development, so am frequently plugging in various phones and wanting to connect them to the VM. Frequently when I plug a device in, it connects to the host and shows up as "Busy" in the USB devices list. If I select it, it transitions to "Captured", but isn't actually visible to the guest; it's also been detached from the host at that point.

When things get in that state, that device is basically "stuck" until I completely shut down the VM/VBox and restart -- even if I unplug the device, it remains displayed in the USB devices list as "Captured". Any attempts to select it again give a dialog box ("busy with a previous request") showing an E_INVALIDARG error from the IHostUSBDevice interface. There doesn't seem to be any particular pattern for when this happens, but it happens frequently enough -- around 50% of the time when plugging a device in. It's also not specific to any particular device, though I've only tried various phones and other similar devices.

I've attached VBox.log, though there doesn't seem to be much interesting -- the messages at the end, e.g.:

01:04:29.330 VUSB: attached '00000000037151f0[proxy 0955:7820]' to port 2
01:09:04.888 VUSB: attached '00000000037151f0[proxy 0955:7100]' to port 2
01:28:45.744 VUSB: attached '00000000037151f0[proxy 0955:7100]' to port 2

Are successful attachment of a different device (same device, in normal and in firmware flash mode). The failing device is 22B8:41DB and isn't mentioned in the log.

Batch Modify
Note: See TracBatchModify for help on using batch modify.
Note: See TracQuery for help on using queries.

© 2024 Oracle Support Privacy / Do Not Sell My Info Terms of Use Trademark Policy